The greatest joy is the joy of anticipation, so find some pics of what I'll be shipping today here:
[img]http://theremin.tfrenkel.com/images/all3parts_2_anno.jpg[/img]
[img]http://theremin.tfrenkel.com/images/bc_n_jump_a.jpg[/img]
(right-click on the pics and select "display picture" from the context menu, can't understand why they are so shrunk here, since I resized them already to 400x300px...)
[b]A[/b] is the 2pin male/6pin female connector which will be soldered onto the EPro's volume board instead of R67 or any previous modification. 2 solderings, that's all.
[b]B[/b] is the EPVM1345 module (the circuit board is just about 0.8x1.0 inch) with
- [b]B1[/b] the 6pin male connector which will snap into [b]A[/b], keep the backpack module in place and make the connection to the volume board with the outer 2 of these 6 pins.
- [b]B2[/b] the 9pin male conncector which takes either the jumper [b]C[/b] in one of 4 positions or the connector of the pre-wired rotary switch (no pics yet available).
[b]C[/b] is the jumper which can take 4 positions (the module is fool-proof, each non-documented jumper setting will give no volume at all in order to protect the volume board):
1.) original state as with R67 in place
2.) Moog's mod state as with Moog's mod in place
3.) Thierry's mod 1, smoother than setting 2
4.) Thierry's mod 2, still smoother than setting 3
Those who ordered the optional rotary switch will have 4 similar switch positions. The rotary switch comes wired with a ca. 16 inch long ribbon cable and a fitting 9pin female connector which fits only in one position.
